- Joined
- Jan 8, 2005
- Messages
- 2,272
- Location
- In a van, down by the river
- Main Job

- Secondary Job

- Third Job

- Server
- Quetzalcoatl
- Linkshell
- Pimps 4 life!
I recently bought a new mobo and it's looking like i'm having power issues.
When I try to put my hard drive in it wont power up, yet when I take out the IDE ribbon, BAM! it powers up. Also, the Bio's dont show up and I'm not getting a signal from the video card even though it is powering up.
I assume its a powersupply issue because the Mobo specs are higher then my power supply's output.
Requirements:
+3.3v Must be "28A" or more
+5v Must be "28A" or more
+12v Must be "18A" or more
and my power supply specs:
+3v: 24A
+5v: 38A
+12v1: 15A
+12v2: 15A
Would this be causing these problems or would it be a defective Mobo?
When I try to put my hard drive in it wont power up, yet when I take out the IDE ribbon, BAM! it powers up. Also, the Bio's dont show up and I'm not getting a signal from the video card even though it is powering up.
I assume its a powersupply issue because the Mobo specs are higher then my power supply's output.
Requirements:
+3.3v Must be "28A" or more
+5v Must be "28A" or more
+12v Must be "18A" or more
and my power supply specs:
+3v: 24A
+5v: 38A
+12v1: 15A
+12v2: 15A
Would this be causing these problems or would it be a defective Mobo?